Also in that last post, but I received the Dream Valley body in yellow for Tennant, so naturally I w

Also in that last post, but I received the Dream Valley body in yellow for Tennant, so naturally I went right about cutting it up, haha. He was way too tall compared to Daniel and Conchita. He’s still a bit too tall but any further height would be harder to remove. I removed a chunk from the ankles and shortened the neck.
It wasn’t too hard, just a lot of sanding to smooth it out. I did it once before on a Resinsoul body and used Milliput to connect the pieces which I think was less visible, but I got lazy here and used superglue since I could always Milliput later.
What I did was stick the calves onto the feet, then draw two level lines around them by holding a pencil parallel to the table and rotating the calves. I drew perpendicular lines across (like a train track) and also marked the back center to keep things lined up. I cut the pieces out with a Dremel (saw might’ve been better but I don’t have a good one) and used a coarse sandpaper flat on the counter to get the edges flat and even. I glued them together by lining up the back center lines and the internal channel, then sanded it smooth.
1. Dream Valley B4-04 51cm boy body in yellow with mods and Dollshe 18M Fashion Maxi Mystic hand in Oriental 2. Custom 3D printed head and body with Resinsoul Tang limbs and Dollshe 28M Fashion Maxi hands 3. Dream Valley B4-04 51cm boy body in white, unmodded