Here is a 3D printed Microfusion Cell my buddy sent to me a while back and I just finished it up. At

Here is a 3D printed Microfusion Cell my buddy sent to me a while back and I just finished it up. At least I think I’m finished with it? I can’t decide if I should weather it or not. Well, I have one more so maybe I will keep this one clean. For the paint I used Krylon OSHA safety yellow, Krylon OSHA black and Rustoleum Dark Steel. I didn’t have any water slide decal paper so I had to use Velum instead. Once I cut out the prints I had, I superglued them in place and then I applied two coats of Krylon Triple Thick clear glaze. Hope y'all like it.

Facebook.com/chunkanukeprops
L1B3RTYPR1M3 on Instagram