#worbla cosplay
You can’t wait to start making your home-brewed suit of armor, but you’re not sure what you’ll need before you sit down. Here are some basic tools that you’ll use whenever you’re working with Wonderflex and Worbla:
Pencil
So you can mark where you will cut.
Paper
If you’re prone to making mistakes, it’s good to make stencils on paper and cut out each piece according to them.
Tape
For keeping stencils down.
Scissors
For long, straight cuts and trimming frayed edges.
Exacto knife
For cutting intricate designs. You’ll want to get a lotof these.
Heat gun
A hairdryer on PCP. A heat gun is, hands-down, the single most useful tool you will have at your disposal. It heats up quickly, will let you target specific areas, and gets the plastic nice and malleable faster than anything else will. You can get one for a little over $20 on Amazon. A microwave or heater will do if you don’t have a heat gun, but trust me, this is so much better.
And that’s it. Six tools and a whole world of prop-making has opened up before you.
This guide was made under the wing of Costume Discounters (www.costumediscounters.com). Please go check out their site!! They sell wigs, shoes, shirts, essentials…all sorts of goodies.